Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Example:
Manual operation:
[SENSe:]PMETer<p>:UPDate[:STATe] <State>
This command turns continuous update of power sensor measurements on and off.
If on, the results are update even if a single sweep is complete.
Suffix:
<p>
Parameters:
<State>
Example:
Manual operation:
UNIT<n>:PMETer<p>:POWer <Unit>
This command selects the unit for absolute power sensor measurements.
Suffix:
<n>
<p>
Parameters:
<Unit>
Example:
Manual operation:
UNIT<n>:PMETer<p>:POWer:RATio <Unit>
This command selects the unit for relative power sensor measurements.
Suffix:
<n>
<p>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
ON | 1
Switches the function on
PMET1 ON
Switches the power sensor measurements on.
See
"State"
on page 286
See
"Select"
on page 287
Power sensor index
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
PMET1:UPD ON
The data from power sensor 1 is updated continuously.
See
"Continuous Value Update"
irrelevant
Power sensor index
DBM | WATT | W | DB | PCT
*RST:
DBM
UNIT:PMET:POW DBM
See
"Unit/Scale"
on page 287
irrelevant
Power sensor index
Remote commands
on page 286
801
801
Publicité
