Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
OUTPut<up>:IF[:SOURce] <Source>
Defines the type of signal available at one of the output connectors of the
R&S FPL1000.
Suffix:
<up>
Parameters:
<Source>
Example:
Manual operation:
OUTPut<up>:IF:IFFRequency <Frequency>
This command defines the frequency for the IF output of the R&S FPL1000. The IF fre-
quency of the signal is converted accordingly.
This command is available in the time domain and if the IF/VIDEO output is configured
for IF.
Suffix:
<up>
Parameters:
<Frequency>
Manual operation:
OUTPut<up>:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S FPL1000.
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
IF
The measured IF value is available at the IF/VIDEO output con-
nector.
This connector is only available if the R&S FPL1-B5 option is
installed.
The frequency at which the IF value is provided is defined using
OUTPut<up>:IF:IFFRequency
the
VIDeo
The displayed video signal (i.e. the filtered and detected IF sig-
nal, 200mV) is available at the IF/VIDEO output connector.
This setting is required to provide demodulated audio frequen-
cies at the output.
*RST:
IF
OUTP:IF VID
Selects the video signal for the IF/VIDEO output connector.
See
"Data Output"
on page 308
*RST:
50.0 MHz
Default unit: HZ
See
"Data Output"
on page 308
Remote commands
command.
811
811
Publicité
