Rohde & Schwarz FPL1000 Manuel D'utilisation page 825

®
R&S FPL1000
CALCulate<n>:SGRam:CLEar[:IMMediate]
CALCulate<n>:SPECtrogram:CLEar[:IMMediate]
This command resets the spectrogram and clears the history buffer.
Suffix:
<n>
Example:
Manual operation:
CALCulate<n>:SGRam:CONTinuous <State>
CALCulate<n>:SPECtrogram:CONTinuous <State>
This command determines whether the results of the last measurement are deleted
before starting a new measurement in single sweep mode.
This setting applies to all spectrograms in the channel setup.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:SGRam:FRAMe:COUNt <Frames>
CALCulate<n>:SPECtrogram:FRAMe:COUNt <Frames>
This command defines the number of frames to be recorded in a single sweep.
This value applies to all spectrograms in the channel setup.
Suffix:
<n>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Window
//Reset the result display and clear the memory
CALC:SGR:CLE
See "Clear Spectrogram"
Window
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
INIT:CONT OFF
Selects single sweep mode.
INIT;*WAI
Starts the sweep and waits for the end of the sweep.
CALC:SGR:CONT ON
Repeats the single sweep measurement without deleting the
results of the last measurement.
See "Single Sweep / Run Single"
See "Continue Frame"
Window
Remote commands
on page 338
on page 336
on page 337
825 825