Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
CALCulate<n>:LIMit<li>:CONTrol:OFFSet <Offset>
This command defines an offset for a complete limit line.
Compared to shifting the limit line, an offset does not actually change the limit line defi-
nition points.
Suffix:
<n>
<li>
Parameters:
<Offset>
Manual operation:
CALCulate<n>:LIMit<li>:CONTrol:SHIFt <Distance>
This command moves a complete limit line horizontally.
Compared to defining an offset, this command actually changes the limit line definition
points by the value you define.
Suffix:
<n>
<li>
Parameters:
<Distance>
Manual operation:
CALCulate<n>:LIMit<li>:CONTrol:SPACing <InterpolMode>
This command selects linear or logarithmic interpolation for the calculation of limit lines
from one horizontal point to the next.
Suffix:
<n>
<li>
Parameters:
<InterpolMode>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
irrelevant
Limit line
Numeric value.
The unit depends on the scale of the x-axis.
*RST:
0
Default unit: HZ
See
"X-Offset"
on page 438
irrelevant
Limit line
Numeric value.
The unit depends on the scale of the x-axis.
Default unit: HZ
See
"Shift x"
on page 442
Window
Limit line
LINear | LOGarithmic
*RST:
LIN
CALC:LIM:CONT:SPAC LIN
See
"X-Axis"
on page 441
Remote commands
910
910
Publicité
