Rohde & Schwarz FPL1000 Manuel D'utilisation page 716

®
R&S FPL1000
See also
Suffix:
<n>
<m>
Return values:
<PeakPower>
Usage:
Manual operation:
Measuring the RMS power
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:RMS:AVERage:RESult?
This command queries the average RMS of the time domain power. The query is only
possible if averaging has been activated previously using
MARKer<m>:FUNCtion:SUMMary:AVERage
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<RMSPower>
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:RMS:PHOLd:RESult?
This command queries the maximum RMS of the time domain power. The query is only
possible if the peak hold function has been activated previously using
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PHOLd.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<RMSPower>
Manuel d'utilisation 1179.5860.09 - 12
INITiate<n>:CONTinuous
Window
Marker
Peak power of the signal during the measurement time.
Query only
See "Results"
INITiate<n>:CONTinuous
Window
Marker
RMS power of the signal during the measurement time.
Query only
INITiate<n>:CONTinuous
Window
Marker
RMS power of the signal during the measurement time.
Configuring and performing measurements
on page 620.
on page 234
CALCulate<n>:
on page 705.
on page 620.
on page 620.
Remote commands
716 716