Rohde & Schwarz FPL1000 Manuel D'utilisation page 881

®
R&S FPL1000
10.8.8.10 Phase noise measurement marker
The following commands control the phase noise measurement marker function.
Useful commands for phase noise markers described elsewhere
●
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:MAXimum[:
PEAK]
●
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:X
●
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:Y
Remote commands exclusive to phase noise markers
CALCulate<n>:DELTamarker<m>:FUNCtion:PNOise:AUTO
CALCulate<n>:DELTamarker<m>:FUNCtion:PNOise:RESult?
CALCulate<n>:DELTamarker<m>:FUNCtion:PNOise[:STATe]
CALCulate<n>:MARKer<m>:FUNCtion:PNOise:AOFF
CALCulate<n>:MARKer<m>:FUNCtion:PNOise:RESult?
CALCulate<n>:MARKer<m>:FUNCtion:PNOise[:STATe]
CALCulate<n>:DELTamarker<m>:FUNCtion:PNOise:AUTO <State>
This command turns an automatic peak search for the fixed reference marker at the
end of a sweep on and off.
Suffix:
<n>
<m>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:DELTamarker<m>:FUNCtion:PNOise:RESult?
This command queries the result of a phase noise measurement.
If necessary, the command activates the measurement first.
This command is only available in the Spectrum application.
Suffix:
<n>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Window
Marker
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
CALC:DELT:FUNC:PNO:AUTO ON
Activates an automatic peak search for the reference marker in
a phase-noise measurement.
See "Defining Reference Point"
Window
Remote commands
.................................................. 875
............................................... 875
............................................... 876
........................................................... 876
........................................................ 877
........................................................ 877
on page 379
881 881