Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Parameters:
<Bandwidth>
Manual operation:
[SENSe:]POWer:ACHannel:BWIDth:ALTernate<ch> <Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth:ALTernate<ch> <Bandwidth>
This command defines the channel bandwidth of the alternate channels.
If you set the channel bandwidth for the first alternate channel, the R&S FPL1000 sets
the bandwidth of the other alternate channels to the same value, but not the other way
round. The command works hierarchically: to set a bandwidth of the 3rd and 4th chan-
nel, you have to set the bandwidth of the 3rd channel first.
Suffix:
<ch>
Parameters:
<Bandwidth>
Manual operation:
[SENSe:]POWer:ACHannel:BWIDth[:CHANnel<ch>] <Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth[:CHANnel<ch>] <Bandwidth>
This command defines the channel bandwidth of the transmission channels.
Suffix:
<ch>
Parameters:
<Bandwidth>
Manual operation:
[SENSe:]POWer:ACHannel:NAME:ACHannel <Name>
This command defines a name for the adjacent channel.
Parameters:
<Name>
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
Range:
100 Hz to 1000 MHz
*RST:
14 kHz
Default unit: Hz
See
"Channel Bandwidth"
1..n
Alternate channel number
Range:
100 Hz to 1000 MHz
*RST:
14 kHz
Default unit: Hz
See
"Channel Bandwidth"
1..n
Tx channel number
Range:
100 Hz to 1000 MHz
*RST:
14 kHz
Default unit: Hz
See
"Channel Bandwidth"
See
"Channel Bandwidth"
See
"Channel Bandwidth"
String containing the name of the channel
*RST:
ADJ
Remote commands
on page 145
on page 145
on page 145
on page 158
on page 163
639
639
Publicité
