Rohde & Schwarz FPL1000 Manuel D'utilisation page 704

®
R&S FPL1000
Example:
Manual operation:
[SENSe:]SWEep:EGATe:TRACe<t>:STOP<gr> <Time>
This command defines the stop time for a gate range.
Suffix:
<t>
<gr>
Parameters:
<Time>
Example:
Manual operation:
10.6.9.4 Scaling the diagram
The following commands set up the diagram for statistical measurements.
CALCulate<n>:STATistics:PRESet
CALCulate<n>:STATistics:SCALe:AUTO ONCE
CALCulate<n>:STATistics:SCALe:X:RANGe
CALCulate<n>:STATistics:SCALe:X:RLEVel
CALCulate<n>:STATistics:SCALe:Y:LOWer
CALCulate<n>:STATistics:SCALe:Y:UNIT
CALCulate<n>:STATistics:SCALe:Y:UPPer
CALCulate<n>:STATistics:PRESet
This command resets the scale of the diagram (x- and y-axis).
●
Reference level (x-axis)
0.0 dBm
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
ON | 1
Switches the function on
SWE:EGAT:TRAC1:STAT1 ON
Activates gate range 1 for trace 1.
See "Range <x> Use"
Trace
1..n
gate range
The value range depends on the gate period you have set for
the selected trace with
PERiod. The following rules apply:
• the stop time may not be higher than the length of the gate
• the stop time may not be lower than the start time
The reset values depend on the gate range.
• for gate range 1, the stop time is 1 ms
• for gate range 3, the stop time is 3 ms
• for gate range 5, the stop time is 5 ms
Default unit: s
SWE:EGAT:TRAC1:STOP1 5ms
Sets the stopping point for range 1 on trace 1 at 5 ms.
See "Range <x> Start/Stop"
.......................................................................................... 698
..................................................................... 699
........................................................................... 699
........................................................................... 700
............................................................................ 700
............................................................................... 700
............................................................................ 701
Remote commands
on page 225
[SENSe:]SWEep:EGATe:TRACe<t>:
on page 226
704 704