Rohde & Schwarz FPL1000 Manuel D'utilisation page 590

®
R&S FPL1000
By default, the instrument is configured to use dynamic TCP/IP configuration and
obtain all address information automatically. This means that it is safe to establish a
physical connection to the LAN without any previous instrument configuration.
When a DHCP server is used, a new IP address may be assigned each time the PC is
restarted. This address must first be determined on the PC itself. Thus, when using a
DHCP server, it is recommended that you use the permanent computer name, which
determines the address via the DNS server (see
IP address"
Assigning the IP address on the instrument
Risk of network errors
Connection errors can affect the entire network. Contact your network administrator to
obtain a valid IP address.
1. Press the [SETUP] key.
2. Press the "Network + Remote" softkey.
3. Select the "Network" tab.
4. In the "Network + Remote" dialog, toggle the "DHCP On/Off" setting to the required
mode.
If DHCP is "Off", you must enter the IP address manually, as described in the fol-
lowing steps.
Note: When DHCP is changed from "On" to "Off", the previously set IP address
and subnet mask are retrieved.
If DHCP is "On", the IP address of the DHCP server is obtained automatically. The
configuration is saved, and you are prompted to restart the instrument. You can
skip the remaining steps.
Note: When a DHCP server is used, a new IP address may be assigned each time
the instrument is restarted. This address must first be determined on the instrument
itself. Thus, when using a DHCP server, it is recommended that you use the per-
manent computer name, which determines the address via the DNS server
(See
ter 9.5.1.3, "How to change the instrument
5. Enter the "IP Address", for example 192.0.2.0. The IP address consists of four
number blocks separated by dots. Every block contains a maximum of 3 numbers.
6. Enter the "Subnet Mask", for example 255.255.255.0. The subnet mask consists of
four number blocks separated by dots. Every block contains a maximum of 3 num-
bers.
7. Close the dialog box.
Manuel d'utilisation 1179.5860.09 - 12
on page 585).
"Using a DNS server to determine the IP address"
Network operation and remote control
How to set up a network and remote control
"Using a DNS server to determine the
on page 585 and
name", on page 586).
Chap-
590 590