Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Manual operation:
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:SELect <MeasType>
This command selects a power measurement and turns the measurement on.
Suffix:
<n>
<m>
<sb>
Parameters:
<MeasType>
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
CPOWer
Channel power measurements.
Returns the channel power. The unit of the return values
depends on the scaling of the y-axis:
• logarithmic scaling returns the power in the current unit
• linear scaling returns the power in W
For SEM measurements, the return value is the channel power
of the reference range.
PPOWer
Peak power measurements.
Returns the peak power. The unit of the return values depends
on the scaling of the y-axis:
• logarithmic scaling returns the power in the current unit
• linear scaling returns the power in W
For SEM measurements, the return value is the peak power of
the reference range.
Note that this result is only available if the power reference type
is set to peak power (see
on page 670).
OBANdwidth | OBWidth
Occupied bandwidth.
Returns the occupied bandwidth in Hz.
COBandwidth | COBWidth
<Centroid frequency>,<Frequency offset>
See
Chapter 6.2.6.2, "OBW
See
"C/N"
on page 157
See
"C/N0"
on page 157
Window
Marker
irrelevant
ACPower | MCACpower
Adjacent channel leakage ratio (ACLR), also known as adjacent
channel power or multicarrier adjacent channel.
The R&S FPL1000 performs the measurement on the trace
selected with [SENSe:]POWer:TRACe.
CPOWer
Channel power measurement with a single carrier.
The R&S FPL1000 performs the measurement on the trace
selected with [SENSe:]POWer:TRACe.
Remote commands
[SENSe:]ESPectrum<sb>:RTYPe
results",
on page 161
629
629
Publicité
