Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Manual operation:
FORMat:DEXPort:XDIStrib <XDistribution>
Defines how the x-values of the trace are determined in the frequency domain.
Parameters:
<XDistribution>
Example:
Manual operation:
FORMat:DIMPort:TRACes <Selection>
This command selects the data to be included in a data import file (see
LOAD<n>:TRACe
For details on importing data see
Parameters:
<Selection>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
SINGle
Only a single trace is selected for export, namely the one speci-
MMEMory:STORe<n>:TRACe
fied by the
ALL
Selects all active traces and result tables (e.g. "Result Sum-
mary", marker peak list etc.) in the current application for export
to an ASCII file.
The <trace> parameter for the
command is ignored.
*RST:
SINGle
See
"Export all Traces and all Table Results"
STARtstop | BINCentered
BINCentered
The full measurement span is divided by the number of sweep
points to obtain bins. The x-value of the sweep point is defined
as the x-value at the center of the bin (bin/2).
STARtstop
(Default): The x-value of the first sweep point corresponds to the
starting point of the full measurement span. The x-value of the
last sweep point corresponds to the end point of the full mea-
surement span. All other sweep points are divided evenly
between the first and last points.
FORM:DEXP:XDIS BINC
See
"X-Value Distribution"
on page 834).
Chapter 6.13.3, "How to import
SINGle | ALL
SINGle
Only a single trace is selected for import, namely the one speci-
MMEMory:LOAD<n>:TRACe
fied by the
mand.
Remote commands
command.
MMEMory:STORe<n>:TRACe
on page 458
on page 458
MMEMory:
traces",
on page 834 com-
on page 461.
839
839
Publicité
