Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Suffix:
<up>
Parameters:
<State>
Example:
OUTPut<up>:UPORt[:VALue] <Value>
This command sets the control lines of the user ports.
The assignment of the pin numbers to the bits is as follows:
Bit
Pin
Bits 7 and 6 are not assigned to pins and must always be 0.
The user port is written to with the given binary pattern.
If the user port is programmed to input instead of output (see
STATe
Suffix:
<up>
Parameters:
<Value>
Example:
OUTPut:UPORt:WTRigger:POLarity <State>
Defines the signal polarity that indicates the trigger availability at the optional [AUX
PORT] connector of the R&S FPL1000.
Parameters:
<State>
Manuel d'utilisation 1179.5860.09 - 12
irrelevant
ON | OFF | 0 | 1
OFF | 0
User port is switched to INPut
ON | 1
User port is switched to OUTPut
OUTP:UPOR:STAT ON
7
6
N/A
N/A
on page 786), the output value is temporarily stored.
irrelevant
bit values in hexadecimal format
TTL type voltage levels (max. 5V)
Range:
OUTP:UPOR #B00100100
Sets pins 5 and 7 to 5 V.
HIGH | LOW
LOW
A low signal (= 0 V) indicates the instrument is ready to receive
a trigger.
Setting basic spectrum RF measurement parameters
5
4
3
5
3
4
#B00000000 to #B00111111
Remote commands
2
1
0
7
6
2
INPut<ip>:UPORt:
812
812
Publicité
