Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Command
VTL
1) HP 8594E only
2) Command is accepted without error message, but is ignored
10.11.2.2
Special features of the syntax parsing algorithms for 8566A and 8568A models
The command syntax is very different for models A and B. Different names are
assigned to identical instrument functions, and the command structure likewise differs
considerably between models A and models B.
The command structure for models A is as follows:
<command>::= <command
code>[<SPC>][<data>|<step>][<SPC>][<delimiter>][<command
code>]...<delimiter>
<data>::= <Value>[<SPC>][<units
code>][<SPC>][<delimiter>][<SPC>][<data>]...
<step>::= UP|DN
where
<command code> = see Table "Supported Commands"
<Value> = integer or floating-point numerical value
<units code> = DM | -DM | DB | HZ | KZ | MZ | GZ | MV | UV | SC | MS | US
<delimiter> = <CR> | <LF> | <,> | <;> | <ETX>
<SPC> = 32
<ETX> = 3
Command sections given in [ ] are optional.
The R&S FPL1000 GPIB hardware differs from that used in the HP analyzers. There-
fore, the following constraint exists:
<LF>| <EOI> are still used as delimiters since the GPIB hardware is able to identify
them. The other delimiters are identified and evaluated during syntax analysis.
Manuel d'utilisation 1179.5860.09 - 12
Supported subset
VTL <numeric_value>
DB|DM
VTL DN
VTL UP
VTL?
10
10
Emulating other instruments' commands
Function
Corresp. HP-
Models
Video Trigger Level
HP 856xE/
HP 8594E
Remote commands
Status
not available
1015
1015
Publicité
