Rohde & Schwarz FPL1000 Manuel D'utilisation page 620

®
R&S FPL1000
10.5.2 Performing a sequence of measurements
The following commands control the sequencer.
For details on the Sequencer see
ments",
INITiate:SEQuencer:ABORt
INITiate:SEQuencer:IMMediate
INITiate:SEQuencer:MODE
SYSTem:SEQuencer
INITiate:SEQuencer:ABORt
This command stops the currently active sequence of measurements.
You can start a new sequence any time using
on page 614.
Usage:
Manual operation:
INITiate:SEQuencer:IMMediate
This command starts a new sequence of measurements by the Sequencer.
Before this command can be executed, the Sequencer must be activated (see
SYSTem:SEQuencer
Example:
Manual operation:
INITiate:SEQuencer:MODE <Mode>
Defines the capture mode for the entire measurement sequence and all measurement
groups and channels it contains.
Manuel d'utilisation 1179.5860.09 - 12
on page 89.
..................................................................................................... 614
............................................................................................... 614
..................................................................................................... 614
............................................................................................................... 615
Event
See "Sequencer State"
on page 615).
SYST:SEQ ON
Activates the Sequencer.
INIT:SEQ:MODE SING
Sets single sequence mode so each active measurement will be
performed once.
INIT:SEQ:IMM
Starts the sequential measurements.
See "Sequencer State"
Selecting the operating mode and application
Chapter 5.4, "Running a sequence of measure-
INITiate:SEQuencer:IMMediate
on page 92
on page 92
Remote commands
620 620