Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Parameters:
<State>
Example:
CALCulate<n>:STATistics:CCDF[:STATe] <State>
This command turns the "CCDF" on and off.
Suffix:
<n>
Parameters:
<State>
Example:
10.6.9.2
Configuring statistical measurements
The following commands configure the measurement.
Useful commands for configuring statistical measurements described elsewhere:
●
[SENSe:]BANDwidth[:RESolution]
●
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:RLEVel
on page 772
(Make sure the specified reference level is higher than the measured peak value,
see
Remote commands exclusive to statistical measurements:
CALCulate<n>:MARKer<m>:Y:PERCent
CALCulate<n>:STATistics:NSAMples
CALCulate<n>:MARKer<m>:Y:PERCent <Probability>
This command sets a marker to a particular probability value. You can query the corre-
sponding level with CALCulate<n>:MARKer<m>:X.
Using the command turns delta markers into normal markers.
Suffix:
<n>
<m>
Parameters:
<Probability>
Manuel d'utilisation 1179.5860.09 - 12
ON | OFF | 1 | 0
*RST:
CALC:STAT:APD ON
Switches on the APD measurement.
irrelevant
ON | OFF | 1 | 0
*RST:
CALC:STAT:CCDF ON
Switches on the "CCDF" measurement.
CALCulate<n>:MARKer<m>:Y?
Window
Marker
Range:
Default unit: %
Configuring and performing measurements
0
0
on page 764
on page 858).
................................................................................. 695
...................................................................................... 696
0 % to 100 %
Remote commands
701
701
Publicité
