Rohde & Schwarz FPL1000 Manuel D'utilisation page 619

®
R&S FPL1000
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a channel setup.
Setting parameters:
<ChannelName1>
<ChannelName2>
Example:
Usage:
Manual operation:
INSTrument[:SELect] <ChannelType> | <ChannelName>
This command activates a new channel setup with the defined channel setup type, or
selects an existing channel setup with the specified name.
Also see
●
INSTrument:CREate[:NEW]
Parameters:
<ChannelType>
<ChannelName>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Selecting the operating mode and application
String containing the name of the channel setup you want to
rename.
String containing the new channel setup name.
Note that you cannot assign an existing channel setup name to
a new channel setup; this will cause an error.
Channel names can have a maximum of 31 characters, and
must be compatible with the Windows conventions for file
names. In particular, they must not contain special characters
such as ":", "*", "?".
INST:REN 'IQAnalyzer2','IQAnalyzer3'
Renames the channel setup with the name 'IQAnalyzer2' to
'IQAnalyzer3'.
Setting only
See "Changing the Channel setup Name"
on page 611
Channel type of the new channel setup.
For a list of available channel setup types see
LIST?
on page 612.
String containing the name of the channel setup.
INST IQ
INST 'MyIQSpectrum'
Selects the channel setup named 'MyIQSpectrum' (for example
before executing further commands for that channel setup).
See "Spectrum" on page 86
See "I/Q Analyzer" on page 86
See "AM FM PM Analog Demod"
See "Noise Figure" on page 86
See "Phase Noise" on page 86
See "Vector Signal Analysis (VSA)"
See "Defining a channel setup"
See "New Channel Setup"
Remote commands
on page 70
INSTrument:
on page 86
on page 87
on page 88
on page 89
619 619