Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
This function is not available in all applications and measurements.
Parameters:
<Mode>
Example:
[SENSe:]FREQuency:CENTer <Frequency>
This command defines the center frequency.
Parameters:
<Frequency>
Example:
Manual operation:
[SENSe:]FREQuency:CENTer:STEP <StepSize>
This command defines the center frequency step size.
You can increase or decrease the center frequency quickly in fixed steps using the
SENS:FREQ UP AND SENS:FREQ DOWN commands, see
CENTer
Parameters:
<StepSize>
Manuel d'utilisation 1179.5860.09 - 12
CSPan | SSTop
CSPan
span / center
SSTop
start / stop frequency
FREQ:ANN SST
The allowed range and f
UP
Increases the center frequency by the step defined using the
[SENSe:]FREQuency:CENTer:STEP
DOWN
Decreases the center frequency by the step defined using the
[SENSe:]FREQuency:CENTer:STEP
*RST:
Default unit: Hz
FREQ:CENT 100 MHz
FREQ:CENT:STEP 10 MHz
FREQ:CENT UP
Sets the center frequency to 110 MHz.
See
"PS Frequency"
See
"Center Frequency"
See
"Frequency"
on page 755.
f
is specified in the data sheet.
max
Range:
*RST:
Default unit: Hz
Setting basic spectrum RF measurement parameters
is specified in the data sheet.
max
fmax/2
on page 305
on page 311
on page 344
1 to fMAX
0.1 x span
Remote commands
command.
command.
[SENSe:]FREQuency:
761
761
Publicité
