Rohde & Schwarz FPL1000 Manuel D'utilisation page 813

®
R&S FPL1000
Example:
SYSTem:SPEaker[:STATe] <State>
This command switches the built-in loudspeaker on or off for demodulated signals.
This setting applies only to the current application.
The command is available in the time domain in Spectrum mode and in Analog Modu-
lation Analysis mode.
To set the volume, use the
Parameters:
<State>
Example:
Manual operation:
SYSTem:SPEaker:MUTE
Temporarily disables the audio output via the built-in loudspeakers.
Example:
Manual operation:
SYSTem:SPEaker:VOLume <Volume>
This command defines the volume of the built-in loudspeaker for demodulated signals.
This setting is maintained for all applications.
The command is available in the time domain in Spectrum mode and in Analog Modu-
lation Analysis mode.
Note that you must switch the loudspeaker on first, using the
STATe]
Manuel d'utilisation 1179.5860.09 - 12
HIGH
A high signal (= 5 V) indicates the instrument is ready to receive
a trigger.
OUTP:UPOR:WTR:POL HIGH
The R&S FPL1000 waits for a 5-V-signal at the AUX PORT con-
nector before accepting a trigger signal.
SYSTem:SPEaker:VOLume
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
SYST:SPE ON
SYST:SPE:VOL 0.5
Sets the loudspeaker to half the full volume.
See "Data Output"
See "Loudspeaker"
SYST:SPE:MUTE
See "Data Output"
command.
Setting basic spectrum RF measurement parameters
on page 308
on page 387
on page 308
Remote commands
command.
SYSTem:SPEaker[:
813 813