Rohde & Schwarz FPL1000 Manuel D'utilisation page 802

®
R&S FPL1000
Parameters:
<Unit>
Example:
Manual operation:
10.8.5.3 Internal generator commands
The following commands are required to configure an internal generator. They are only
available if the Tracking Generator option R&S FPL1-B9 is installed.
For details see
Useful commands for internal generators described elsewhere:
●
Chapter 10.6.3.1, "Configuring the compression point
●
Independant CW source commands
●
Tracking generator
●
Power sweep commands
●
Programming example for a tracking generator
Independant CW source commands
The following commands are required to configure an internal generator as an inde-
pendant CW source.
OUTPut<up>[:STATe]
SOURce<si>:INTernal:FREQuency
SOURce<si>:POWer[:LEVel][:IMMediate][:AMPLitude]
SOURce<si>:POWer[:LEVel][:IMMediate]:OFFSet
OUTPut<up>[:STATe] <State>
Enables or disables the internal generator. The generator signal is output at the GEN
Output 50 Ω connector on the front panel.
Suffix:
<up>
Parameters:
<State>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
DB | PCT
*RST: DB
UNIT:PMET:POW:RAT DB
See "Unit/Scale"
Chapter 6.3.3.1, "Basics on the internal
commands..................................................................................... 798
.............................................................................................. 801
..................................................................................................................... 796
......................................................................................... 797
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST: 0
OUTP ON
See "State" on page 299
on page 287
generator",
measurement",
........................................................................... 796
........................................................ 803
........................................................... 797
.................................................................. 797
Remote commands
on page 291.
on page 626
802 802