Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
●
You can only use power classes for which limits are defined.
Suffix:
<n>
<li>
<sb>
<pc>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:LIMit[:STATe] <State>
This command selects the limit check mode for each power class.
Suffix:
<n>
<li>
<sb>
<pc>
Parameters:
<State>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
irrelevant
irrelevant
1 to 3
1..n
power class
ON | OFF | 1 | 0
*RST:
0
CALC:LIM:ESP:PCL1 ON
Activates the first defined power class.
See
"Used Power Classes:"
irrelevant
irrelevant
1 to 3
1..n
power class
ABSolute | RELative | AND | OR
ABSolute
Evaluates only limit lines with absolute power values
RELative
Evaluates only limit lines with relative power values
AND
Evaluates limit lines with relative and absolute power values. A
negative result is returned if both limits fail.
OR
Evaluates limit lines with relative and absolute power values. A
negative result is returned if at least one limit failed.
*RST:
REL
CALC:LIM:ESP:PCL:LIM ABS
See
"Used Power Classes:"
Remote commands
on page 188
on page 188
680
680
Publicité
