Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Example:
Manual operation:
10.8.3.4
Scaling the Y-axis
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:AUTO ONCE
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:MODE
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:RPOSition
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y:SPACing
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe] <Range>
This command defines the display range of the y-axis (for all traces).
Note that the command works only for a logarithmic scaling. You can select the scaling
with DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y:SPACing.
Suffix:
<n>
<w>
<t>
Parameters:
<Range>
Example:
Manual operation:
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:AUTO ONCE
Automatic scaling of the y-axis is performed once, then switched off again (for all
traces).
Suffix:
<n>
<t>
Manual operation:
DISPlay[:WINDow<n>][:SUBWindow<w>]:TRACe<t>:Y[:SCALe]:MODE <Mode>
This command selects the type of scaling of the y-axis (for all traces).
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
INP:GAIN:STAT ON
Switches on 20 dB preamplification.
See
"Preamplifier"
on page 322
Window
subwindow
Not supported by all applications
irrelevant
Range:
1 dB to 200 dB
*RST:
100 dB
Default unit: HZ
DISP:TRAC:Y 110dB
See
"Range"
on page 323
Window
irrelevant
See
"Auto Scale Once"
Remote commands
............................................ 775
................................ 775
.......................... 776
.......................................... 776
on page 323
..................... 775
781
781
Publicité
