Rohde & Schwarz FPL1000 Manuel D'utilisation page 816

®
R&S FPL1000
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>:AREA
This command defines the zoom area for a multiple zoom.
To define a zoom area, you first have to turn the zoom on.
1 = origin of coordinate system (x1 = 0, y1 = 0)
2 = end point of system (x2 = 100, y2= 100)
3 = zoom area (e.g. x1 = 60, y1 = 30, x2 = 80, y2 = 75)
Suffix:
<n>
<w>
<zn>
Parameters:
<x1>
<y1>
<x2>
Manuel d'utilisation 1179.5860.09 - 12
<x1>,<y1>,<x2>,<y2>
Window
subwindow
Not supported by all applications
Selects the zoom window.
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
Default unit: PCT
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
Default unit: PCT
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
Default unit: PCT
Setting basic spectrum RF measurement parameters
0 to 100
0 to 100
0 to 100
Remote commands
816 816