Rohde & Schwarz FPL1000 Manuel D'utilisation page 720

®
R&S FPL1000
10.6.11.1 Activating the measurement
The following command activates harmonic distortion measurement.
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics[:STATe]
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics[:STATe] <State>
This command turns the harmonic distortion measurement on and off.
Note the following:
●
If you perform the measurement in the frequency domain, the search range for the
frequency of the first harmonic, whose power is determined, is defined by the last
span.
●
If you perform the measurement in the time domain, the current center frequency is
used as the frequency of the first harmonic. Thus, the frequency search is
bypassed. The first harmonic frequency is set by a specific center frequency in
zero span before the harmonic measurement is started.
Suffix:
<n>
<m>
Parameters:
<State>
Example:
10.6.11.2 Configuring the measurement
The following commands control the harmonic distortion measurement.
Useful commands for harmonic distortion measurements described elsewhere
●
CALCulate<n>:MARKer<m>:FUNCtion:CENTer
●
[SENSe:]SWEep:TIME:AUTO
Remote commands exclusive to harmonic distortion measurements
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:BANDwidth:AUTO
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:NHARmonics
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:PRESet
CALCulate<n>:MARKer<m>:FUNCtion:HARMonics:BANDwidth:AUTO <State>
This command selects the resolution bandwidth of the harmonic in respect to the band-
width of the first harmonic.
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
Window
Marker
ON | OFF | 1 | 0
*RST: 0
CALC:MARK:FUNC:HARM ON
Activates the harmonic distortion measurement.
on page 770
Remote commands
................................................. 714
on page 753
................................. 714
......................................... 715
.................................................. 715
720 720