Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
<y1>
<x2>
<y2>
Manual operation:
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM[:STATe] <State>
This command turns the zoom on and off.
Suffix:
<n>
<w>
Parameters:
<State>
Example:
Manual operation:
10.8.6.2
Using the multiple zoom
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>:AREA
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:MULTiple<zn>[:STATe]
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
See
"Single Zoom"
on page 450
Window
subwindow
Not supported by all applications
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
DISP:ZOOM ON
Activates the zoom mode.
See
"Single Zoom"
on page 450
See
"Restore Original Display"
Remote commands
on page 452
................................ 810
.............................. 811
815
815
Publicité
