Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
[SENSe:]ESPectrum<sb>:SSETup <State>
Enables or disables symmetrical configuration of the range settings.
See
Suffix:
<sb>
Parameters:
<State>
Manual operation:
10.6.7.5
Configuring the reference range
The following commands define the reference range for the SEM sweep list.
[SENSe:]ESPectrum<sb>:BWID
[SENSe:]ESPectrum<sb>:FILTer[:RRC]:ALPHa
[SENSe:]ESPectrum<sb>:FILTer[:RRC][:STATe]
[SENSe:]ESPectrum<sb>:RRANge?
[SENSe:]ESPectrum<sb>:RTYPe
[SENSe:]ESPectrum<sb>:BWID <Bandwidth>
This command defines the channel bandwidth of the reference range.
The bandwidth is available if the power reference is the channel power.
Suffix:
<sb>
Parameters:
<Bandwidth>
Manual operation:
[SENSe:]ESPectrum<sb>:FILTer[:RRC]:ALPHa <Alpha>
This command defines the roll-off factor for the RRC filter.
The RRC filter is available if the power reference is the channel power.
Manuel d'utilisation 1179.5860.09 - 12
"Ranges and range settings"
1 to 3
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST:
See
1 to 3
Sub block in a Multi-SEM measurement
minimum span ≤ value ≤ span of reference range
*RST:
Default unit: Hz
See
Configuring and performing measurements
on page 170.
0
"Symmetrical Setup"
on page 185
.............................................................................................. 669
...................................................................... 669
.................................................................... 670
....................................................................................... 670
............................................................................................ 670
3.84 MHz
"Tx Bandwidth"
on page 187
Remote commands
675
675
Publicité
