Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
●
Remote control via SCPI
●
Chapter 9.2.2.4, "STATus:OPERation
●
Chapter 9.2.2.6, "STATus:QUEStionable:ACPLimit
●
Chapter 9.2.2.7, "STATus:QUEStionable:EXTended
●
Chapter 9.2.2.9, "STATus:QUEStionable:FREQuency
●
Chapter 9.2.2.10, "STATus:QUEStionable:LIMit
●
Chapter 9.2.2.11, "STATus:QUEStionable:LMARgin
●
Chapter 9.2.2.12, "STATus:QUEStionable:POWer
●
Chapter 9.2.2.13, "STATus:QUEStionable:TEMPerature
●
Chapter 9.2.2.14, "STATus:QUEStionable:TIMe
●
General status register commands
●
Reading out the CONDition part
●
Reading out the EVENt part
●
Controlling the ENABle part
●
Controlling the negative transition part
●
Controlling the positive transition part
●
Service request
10.12.1 General status register commands
STATus:PRESet
STATus:QUEue[:NEXT]?
STATus:PRESet
This command resets the edge detectors and ENABle parts of all registers to a defined
value. All PTRansition parts are set to FFFFh, i.e. all transitions from 0 to 1 are
detected. All NTRansition parts are set to 0, i.e. a transition from 1 to 0 in a
CONDition bit is not detected. The ENABle part of the STATus:OPERation and
STATus:QUEStionable registers are set to 0, i.e. all events in these registers are not
passed on.
Usage:
STATus:QUEue[:NEXT]?
This command queries the most recent error queue entry and deletes it.
Positive error numbers indicate device-specific errors, negative error numbers are error
messages defined by SCPI. If the error queue is empty, the error number 0, "No error",
is returned.
This command is identical to the
Usage:
Manuel d'utilisation 1179.5860.09 - 12
................................................................................ 1017
....................................................................................... 1017
........................................................................................ 1018
............................................................................................................. 1019
........................................................................................................................... 1016
....................................................................................................... 1016
Event
SYSTem:ERRor[:NEXT]?
Query only
register",
on page 561
register",
register",
register",
register",
register",
register",
register",
register",
............................................................................ 1016
..................................................................... 1018
....................................................................... 1019
command.
Remote commands
Using the status register
on page 563
on page 564
on page 565
on page 566
on page 566
on page 567
on page 568
on page 568
1022
1022
Publicité
