Rohde & Schwarz FPL1000 Manuel D'utilisation page 729

®
R&S FPL1000
CALC:MARK:FUNC:MDEP:RES?
//Queries the measurement results.
//If the results are not accurate, change the position of the
//the temporary markers manually.
//----Changing the position of the temp markers-----
CALC:MARK:X 100MHZ
//Positions the reference marker on 100 MHz.
CALC:DELT2:X 5KHZ
//Positions delta marker 2 and 3 at a distance of 5 kHz to the reference marker.
CALC:DELT3:X 1KHZ
//Corrects the position of delta marker 3 by 1 kHz.
CALC:MARK:FUNC:MDEP:RES?
//Queries the measurement results for the repositioned markers.
10.6.14 Remote commands for EMI measurements
The following commands are required to perform EMI measurements in a remote envi-
ronment. This measurement requires the R&S FPL1-K54 option.
The following tasks specific to the EMI application are described here:
●
Activating EMI
●
Configuring EMI markers
●
Configuring the EMI final test
●
Configuring EMI limit lines
●
Controlling LISN
●
Retrieving EMI results
●
Evaluating the results
●
Programming example: EMI measurement
10.6.14.1 Activating EMI measurement
EMI measurement must be activated explicitely.
CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement[:STATe]
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement[:STATe]
CALCulate<n>:DELTamarker<m>:FUNCtion:FMEasurement[:STATe] <State>
CALCulate<n>:MARKer<m>:FUNCtion:FMEasurement[:STATe] <State>
This command turns the EMI measurement marker functionality on and off.
Suffix:
<n>
<m>
Parameters:
<State>
Manuel d'utilisation 1179.5860.09 - 12
measurement........................................................................................ 723
.............................................................................................. 724
....................................................................................... 725
............................................................................................ 726
............................................................................................................. 726
................................................................................................... 728
.................................................................................................... 729
irrelevant
irrelevant
ON | OFF | 1 | 0
Remote commands
Configuring and performing measurements
................................................................ 729
................................... 723
............................................ 723
729 729