Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Command
RLPOS
RQS
10.11.2.4
Model-dependent default settings
If the GPIB language is switched over to an 85xx model, the GPIB address is automati-
cally switched over to 18 provided that the default address of the R&S FPL1000 (20) is
still set. If a different value is set, this value is maintained. Upon return to SCPI, this
address remains unchanged.
The following table shows the default settings obtained after a change of the GPIB lan-
guage and for the commands IP, KST and RESET:
Model
8566A/B
8568A/B
8560E
8561E
8562E
8563E
8564E
8565E
8594E
Stop frequency
The stop frequency given in the table may be limited to the corresponding frequency
range of the R&S FPL1000.
Command LF sets the stop frequency for 8566A/B to a maximum value of 2 GHz.
Test points (trace points)
The number of trace points is switched over only upon transition to the REMOTE state.
Manuel d'utilisation 1179.5860.09 - 12
Known Differences
Adapts the position of the reference level even if the tracking generator normalization is
not active.
Supported bits:
1 (Units key pressed)
2 (End of Sweep)
3 (Device error)
4 (Command complete)
5 (Illegal command)
Start Freq.
# of Trace
Points
1001
2 GHz
1001
0 Hz
601
0 Hz
601
0 Hz
601
0 Hz
601
0 Hz
601
0 Hz
601
0 Hz
401
0 Hz
Remote commands
Emulating other instruments' commands
Stop Freq.
Ref Level
22 GHz
0 dBm
1.5 GHz
0 dBm
2.9 GHz
0 dBm
6.5 GHz
0 dBm
13.2 GHz
0 dBm
26.5 GHz
0 dBm
40 GHz
0 dBm
50 GHz
0 dBm
3 GHz
0 dBm
Input Coupling
AC
AC
AC
AC
AC
AC
AC
AC
AC
1017
1017
Publicité
