Rohde & Schwarz FPL1000 Manuel D'utilisation page 828

®
R&S FPL1000
CALCulate<n>:SGRam:THReedim[:STATe] <State>
CALCulate<n>:SPECtrogram:THReedim[:STATe] <State>
Activates or deactivates a 3-dimensional spectrogram for the selected result display.
Suffix:
<n>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:SGRam:TRACe <Trace>
CALCulate<n>:SPECtrogram:TRACe <Trace>
This command determines the trace in the result display the Spectrogram is based on.
Suffix:
<n>
Parameters:
<Trace>
Example:
CALCulate<n>:SGRam:TSTamp:DATA? <Frames>
CALCulate<n>:SPECtrogram:TSTamp:DATA? <Frames>
This command queries the starting time of the frames.
The return values consist of four values for each frame. If the Spectrogram is empty,
the command returns '0,0,0,0'. The times are given as delta values, which simplifies
evaluating relative results; however, you can also calculate the absolute date and time
as displayed on the screen.
The frame results themselves are returned with TRAC:DATA? SGR
See
Manuel d'utilisation 1179.5860.09 - 12
Window
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
*RST:
CALC:SPEC:THR:STAT ON
See
Window
TRACE1 | TRACE2 | TRACE3 | TRACE4 | TRACE5 | TRACE6
How many traces are available depends on the selected result
display.
CALC2:SPEC:TRAC TRACE3
TRACe<n>[:DATA]
on page 829.
Setting basic spectrum RF measurement parameters
0
"3D Spectrogram State"
Remote commands
on page 419
828 828