Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Example:
Manual operation:
CALCulate<n>:STATistics:NSAMples <Samples>
This command defines the number of samples included in the analysis of statistical
measurement functions.
Suffix:
<n>
Parameters:
<Samples>
Example:
Manual operation:
10.6.9.3
Using gate ranges for statistical measurements
The following commands control gated statistical measurements.
[SENSe:]SWEep:EGATe:TRACe<t>:COMMent
[SENSe:]SWEep:EGATe:TRACe<t>:PERiod
[SENSe:]SWEep:EGATe:TRACe<t>:STARt<gr>
[SENSe:]SWEep:EGATe:TRACe<t>[:STATe<gr>]
[SENSe:]SWEep:EGATe:TRACe<t>:STOP<gr>
[SENSe:]SWEep:EGATe:TRACe<t>:COMMent <Comment>
This command defines a comment for the gate of a particular trace.
Suffix:
<t>
Parameters:
<Comment>
Example:
Manual operation:
[SENSe:]SWEep:EGATe:TRACe<t>:PERiod <Length>
This command defines the length of the gate for all traces.
The gate length applies to all traces.
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
CALC1:MARK:Y:PERC 95PCT
Positions marker 1 to a probability of 95 %.
See
"Percent Marker (CCDF only)"
Window
Range:
Min: 100, Max: depends on the RBW filter
*RST:
100000
CALC:STAT:NSAM 500
Sets the number of measurement points to be acquired to 500.
See
"Number of Samples"
...................................................................... 696
........................................................................... 696
..................................................................... 697
......................................................................... 697
...................................................................... 698
Trace
String containing the comment.
SWE:EGAT:TRAC1:COMM 'MyComment'
Defines a comment for the gate in trace 1.
See
"Comment"
on page 225
Remote commands
on page 223
on page 224
702
702
Publicité
