Rohde & Schwarz FPL1000 Manuel D'utilisation page 671

®
R&S FPL1000
[SENSe:]ESPectrum<sb>:RANGe<ri>:LIMit<li>:RELative:STOP:FUNCtion
This command enables the use of a function when defining the relative limit for a SEM
range.
Suffix:
<sb>
<ri>
<li>
Parameters:
<Function>
Example:
Manual operation:
[SENSe:]ESPectrum<sb>:RANGe<ri>:LIMit<li>:STATe <State>
This command selects the limit check mode for all SEM ranges (<range> is irrelevant).
Suffix:
<sb>
<ri>
Manuel d'utilisation 1179.5860.09 - 12
<Function>
1 to 3
1..n
Selects the SEM range.
1..n
Power class for which the limit is defined.
OFF | MAX
Defines the function to be used to determine the relative limit
line stop value
MAX
The maximum of the relative and the absolute level is used as
the limit stop value. Use the
RANGe<ri>:LIMit<li>:RELative:STOP
]ESPectrum<sb>:RANGe<ri>:LIMit<li>:RELative:
STOP:ABS
OFF
No function is used, the relative limit line is defined by a fixed
relative stop value. Use the
RANGe<ri>:LIMit<li>:RELative:STOP
this value.
*RST:
SENSe:ESPectrum:RANGe:LIMit:RELative:STOP:
FUNCtion MAX
For a detailed example see
measurement",
See "Rel Limit Start / Stop <n>"
1 to 3
1..n
Selects the SEM range.
Configuring and performing measurements
[SENSe:]ESPectrum<sb>:
commands to define these values.
[SENSe:]ESPectrum<sb>:
OFF
Chapter 10.6.7.10, "Example: SEM
on page 678.
on page 183
Remote commands
[SENSe:
and
command to define
671 671