Rohde & Schwarz FPL1000 Manuel D'utilisation page 574

®
R&S FPL1000
Bit No.
3
4 to 14
15
9.2.2.13 STATus:QUEStionable:TEMPerature register
The STATus:QUEStionable:TEMPerature register contains information about possible
temperature deviations that may occur during operation of the R&S FPL1000. A sepa-
rate temperature register exists for each active channel.
You can read out the register with
CONDition?
Table 9-13: Meaning of the bits used in the STATus:QUEStionable:TEMPerature register
Bit No.
0
1 to 14
15
9.2.2.14 STATus:QUEStionable:TIMe register
The STATus:QUEStionable:TIMe register contains information about possible time
errors that may occur during operation of the R&S FPL1000. A separate time register
exists for each active channel.
You can read out the register with
STATus:QUEStionable:TIME[:EVENt]?
Table 9-14: Meaning of the bits used in the STATus:QUEStionable:TIMe register
Bit No.
0
1
Manuel d'utilisation 1179.5860.09 - 12
Meaning
Input Overload
This bit is set if the signal level at the RF input connector exceeds the maximum.
The RF input is disconnected from the input mixer to protect the device. In order to re-enable
measurement, decrease the level at the RF input connector and reconnect the RF input to the
mixer input.
For details on the protection mechanism see
INPut<ip>:ATTenuation:PROTection:RESet
The R&S FPL1000 displays the keyword "INPUT OVLD".
Unused
This bit is always 0.
STATus:QUEStionable:TEMPerature[:EVENt]?
or
Meaning
This bit is set if the frontend temperature sensor deviates by a certain degree from the self-
alignment temperature.
During warmup, this bit is always 1.
For details see "Temperature check"
Unused
This bit is always 0.
Meaning
not used
Sweep time too low
This bit is set if the sweep time is too low.
Network operation and remote control
"RF Input Protection"
on page 785.
STATus:QUEStionable:TEMPerature:
on page 548.
STATus:QUEStionable:TIME:CONDition?
Status reporting system
on page 283 or
or
574 574