Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Parameters:
<Time>
Example:
Manual operation:
CALCulate<n>:TLINe<dl>:STATe <State>
This command turns a time line on and off
Suffix:
<n>
<dl>
Parameters:
<State>
Example:
10.8.10
Defining limit checks
Note that in remote control, upper and lower limit lines are configured using separate
commands. Thus, you must decide in advance which you want to configure. The x-val-
ues for both upper and lower limit lines are defined as a common control line. This con-
trol line is the reference for the y-values for both upper and lower limit lines.
●
Configuring limit lines
●
Managing limit lines
●
Checking the results of a limit check
●
Programming example: using limit lines
10.8.10.1
Configuring limit lines
CALCulate<n>:LIMit<li>:COMMent
CALCulate<n>:LIMit<li>:CONTrol[:DATA]
CALCulate<n>:LIMit<li>:CONTrol:DOMain
CALCulate<n>:LIMit<li>:CONTrol:MODE
CALCulate<n>:LIMit<li>:CONTrol:OFFSet
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Note that you can not set a time line to a position that is higher
than the current sweep time.
Range:
0 s to 1600 s
*RST:
(STATe to OFF)
Default unit: S
CALC:TLIN 10ms
Sets the first time line to 10 ms.
See
"Vertical Line <x>"
Window
1 to 4
time line
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
CALC:TLIN:STAT ON
Turns the first time line on.
..................................................................................................... 901
........................................................................................................ 911
........................................................................... 914
..................................................................... 915
.......................................................................................... 902
................................................................................ 902
.............................................................................. 903
................................................................................ 903
............................................................................... 904
Remote commands
on page 431
907
907
Publicité
