Rohde & Schwarz FPL1000 Manuel D'utilisation page 725

®
R&S FPL1000
Suffix:
<n>
<m>
Return values:
<TOI>
Example:
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:TOI:RESult:MAXimum?
This command queries the results for the maximum third order intercept point mea-
surement (see
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<TOI>
Example:
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:TOI:RESult:MINimum?
This command queries the results for the minimum third order intercept point measure-
ment (see
Manuel d'utilisation 1179.5860.09 - 12
Window
Marker
Third order intercept point.
INIT:CONT OFF
Switches to single sweep mode.
CALC:MARK:FUNC:TOI ON
Switches the intercept measurement.
INIT;*WAI
Starts a sweep and waits for the end.
CALC:MARK:FUNC:TOI:RES?
Outputs the measured value.
Query only
Chapter 6.2.12.3, "TOI
INITiate<n>:CONTinuous
Window
Marker
Maximum third order intercept point.
INIT:CONT OFF
Switches to single sweep mode.
CALC:MARK:FUNC:TOI ON
Switches the intercept measurement.
INIT;*WAI
Starts a sweep and waits for the end.
CALC:MARK:FUNC:TOI:RES:MAX?
Returns the maximum TOI.
Query only
Chapter 6.2.12.3, "TOI
Configuring and performing measurements
results", on page 248).
on page 620.
results", on page 248).
Remote commands
725 725