Rohde & Schwarz FPL1000 Manuel D'utilisation page 855

®
R&S FPL1000
Parameters:
<Limit>
Example:
Manual operation:
CALCulate<n>:MARKer<m>:X:SLIMits:ZOOM[:STATe] <State>
This command adjusts the marker search range to the zoom area for all markers in all
windows.
Suffix:
<n>
<m>
Parameters:
<State>
Example:
Manual operation:
CALCulate<n>:THReshold <Level>
This command defines a threshold level for the marker peak search (for all markers in
all windows).
Note that you must enable the use of the threshold using
THReshold:STATe
Suffix:
<n>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
The value range depends on the frequency range or sweep
time.
The unit is Hz for frequency domain measurements and s for
time domain measurements.
*RST: right diagram border
Default unit: HZ
CALC:MARK:X:SLIM ON
Switches the search limit function on.
CALC:MARK:X:SLIM:RIGH 20MHz
Sets the right limit of the search range to 20 MHz.
See "Search Limits (Left / Right)"
See "Left Limit / Right Limit"
irrelevant
irrelevant
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
CALC:MARK:X:SLIM:ZOOM ON
Switches the search limit function on.
CALC:MARK:X:SLIM:RIGH 20MHz
Sets the right limit of the search range to 20 MHz.
See "Use Zoom Limits"
on page 850.
irrelevant
Remote commands
on page 163
on page 235
on page 365
CALCulate<n>:
855 855