Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage:
10.4 Commands for remote instrument operation
The following commands are required to shutdown or reboot the R&S FPL1000 from a
remote PC.
SYSTem:CLOGging
SYSTem:REBoot
SYSTem:SHUTdown
SYSTem:CLOGging <State>
This command turns logging of remote commands on and off.
Parameters:
<State>
Manual operation:
SYSTem:REBoot
This command reboots the instrument, including the operating system.
SYSTem:SHUTdown
This command shuts down the instrument.
Manuel d'utilisation 1179.5860.09 - 12
Event
................................................................................................................. 609
..................................................................................................................... 609
................................................................................................................ 609
ON | OFF | 1 | 0
ON | 1
Writes all remote commands that have been sent to a file.
The destination is C:
\Users\Public\Documents\Rohde-Schwarz\Analyzer\ScpiLogging
ScpiLog.<no.>.
where <no.> is a sequential number
A new log file is started each time logging was stopped and is
restarted.
OFF | 0
*RST:
0
See
"I/O Logging"
on page 575
Remote commands
Commands for remote instrument operation
615
615
Publicité
