Rohde & Schwarz FPL1000 Manuel D'utilisation page 874

®
R&S FPL1000
<m>
10.8.8.7 Fixed reference marker settings
The following commands configure a fixed reference marker.
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:MAXimum[:PEAK]
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:X
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:Y
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:Y:OFFSet
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed[:STATe]
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:MAXimum[:PEAK]
This command moves the fixed reference marker to the peak power.
Suffix:
<n>
<m>
Example:
Manual operation:
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:X <RefPoint>
This command defines the horizontal position of the fixed delta marker reference point.
The coordinates of the reference may be anywhere in the diagram.
Suffix:
<n>
<m>
Parameters:
<RefPoint>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Marker
Window
Marker
CALC:DELT:FUNC:FIX:RPO:MAX
Sets the reference point level for delta markers to the peak of
the selected trace.
See "Defining a Fixed Reference"
See "Defining Reference Point"
Window
Marker
Numeric value that defines the horizontal position of the refer-
ence.
For frequency domain measurements, it is a frequency in Hz.
For time domain measurements, it is a point in time in s.
*RST: Fixed Reference: OFF
Default unit: HZ
CALC:DELT:FUNC:FIX:RPO:X 128 MHz
Sets the frequency reference to 128 MHz.
See "Defining a Fixed Reference"
See "Defining Reference Point"
Remote commands
...................... 868
................................................ 868
................................................ 869
................................... 869
.................................................. 869
on page 362
on page 379
on page 362
on page 379
874 874