Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Manual operation:
INPut<ip>:IMPedance <Impedance>
This command selects the nominal input impedance of the RF input. In some applica-
tions, only 50 Ω are supported.
Suffix:
<ip>
Parameters:
<Impedance>
Example:
Manual operation:
INPut<ip>:SELect <Source>
This command selects the signal source for measurements, i.e. it defines which con-
nector is used to input data to the R&S FPL1000.
If no additional input options are installed, only RF input is supported.
Suffix:
<ip>
Parameters:
<Source>
Manual operation:
INPut<ip>:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S FPL1000.
See the R&S FPL1000 Getting Started manual for details.
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
See
"YIG-Preselector"
1 | 2
irrelevant
50 | 75
numeric value
User-defined impedance from 50 Ohm to 100000000 Ohm
(=100 MOhm)
User-defined values are only available for the Spectrum applica-
tion, the I/Q Analyzer, and some optional applications.
50 Ω
*RST:
Default unit: OHM
INP:IMP 75
See
"Impedance"
on page 283
See
"Unit"
on page 320
1 | 2
irrelevant
RF
Radio Frequency ("RF INPUT" connector)
*RST:
RF
See
"Radio Frequency State"
Remote commands
on page 284
on page 283
792
792
Publicité
