Rohde & Schwarz FPL1000 Manuel D'utilisation page 835

®
R&S FPL1000
Example:
TRACe<n>[:DATA] <Trace>,<Data>
TRACe<n>[:DATA]? <ResultType>
This command queries current trace data and measurement results.
The data format depends on
Suffix:
<n>
Parameters:
<Trace>
<Data>
Query parameters:
<ResultType>
Return values:
<TraceData>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
32
32-bit floating-point numbers
For I/Q data, 8 bytes per sample are returned for this format set-
ting.
64
64-bit floating-point numbers
Compared to REAL,32 format, twice as many numbers are
returned.
FORM REAL,32
FORMat[:DATA]
Window
Selects the trace to write the data to.
TRACE1 | TRACE2 | TRACE3 | TRACE4 | TRACE5 | TRACE6
Contains the data to transfer.
Selects the type of result to be returned.
TRACE1 | ... | TRACE6
Returns the trace data for the corresponding trace.
For details see Table 10-6.
LIST
Returns the results of the peak list evaluation for Spurious Emis-
sion and Spectrum Emission Mask measurements.
For SEM measurements, one peak per range is returned.
For details see Table 10-7.
SPURious
Returns the peak list of Spurious Emission measurements.
SPECtrogram | SGRam
Returns the results of the spectrogram result display.
For every frame in the spectrogram, the command returns the
power levels that have been measured, one for each sweep
point. The number of frames depends on the size of the history
depth. The power level depends on the unit you have currently
set. For spectrogram trace results, only REAL,32 format is sup-
ported
For more information see tables below.
Remote commands
on page 828.
835 835