Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
[SENSe:]BWIDth:VIDeo:TYPE
[SENSe:]BANDwidth:VIDeo:TYPE
[SENSe:]BWIDth[:RESolution] <Bandwidth>
[SENSe:]BANDwidth[:RESolution] <Bandwidth>
This command defines the resolution bandwidth and decouples the resolution band-
width from the span.
For statistics measurements, this command defines the demodulation bandwidth.
Parameters:
<Bandwidth>
Example:
Manual operation:
[SENSe:]BWIDth[:RESolution]:AUTO <State>
[SENSe:]BANDwidth[:RESolution]:AUTO <State>
This command couples and decouples the resolution bandwidth to the span.
Parameters:
<State>
Example:
Manual operation:
[SENSe:]BWIDth[:RESolution]:RATio <Ratio>
[SENSe:]BANDwidth[:RESolution]:RATio <Ratio>
This command defines the ratio between the resolution bandwidth (Hz) and the span
(Hz).
Note that the ratio defined with this remote command (RBW/span) is reciprocal to that
of the coupling ratio (span/RBW).
Parameters:
<Ratio>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
................................................................................................. 766
........................................................................................... 766
refer to data sheet
*RST:
RBW: AUTO is set to ON; DBW: 3MHz
Default unit: Hz
BAND 1 MHz
Sets the resolution bandwidth to 1 MHz
See
"Analysis Bandwidth"
See
"RBW"
on page 273
See
"Res BW CISPR"
See
"Res BW MIL"
on page 275
See
"RBW"
on page 344
ON | OFF | 0 | 1
*RST:
1
BAND:AUTO OFF
Switches off the coupling of the resolution bandwidth to the
span.
See
"RBW"
on page 273
See
"Default Coupling"
Range:
0.0001 to 1
*RST:
0.01
Remote commands
on page 223
on page 275
on page 334
770
770
Publicité
