Rohde & Schwarz FPL1000 Manuel D'utilisation page 845

®
R&S FPL1000
If you change the horizontal position of marker <md>, marker <ms> changes its hori-
zontal position to the same value.
Suffix:
<n>
<ms>
<md>
Parameters:
<State>
Example:
CALCulate<n>:DELTamarker<ms>:LINK:TO:MARKer<md> <State>
This command links the delta source marker <ms> to any active destination marker
<md> (normal or delta marker).
In Spectrum mode only:
●
If <md> is a delta marker, it is turned into a normal marker. To maintain the delta
marker, use
on page 838.
●
If <md> is the reference marker for the delta marker <ms>, the delta marker is ini-
tially set to the same horizontal position as the normal marker. To change the rela-
tive distance (delta) value again, use
on page 841. Then the delta between the two markers is maintained when you
move the normal marker.
In I/Q Analyzer mode, if <md> is the reference marker for the delta marker <ms>, the
relative distance (delta) between the two markers is maintained when you move the
normal marker.
In other applications, the delta marker is set to the same horizontal position as the
marker <md>, and if <md> is moved along the x-axis, <ms> follows to the same hori-
zontal position.
Suffix:
<n>
<ms>
<md>
Parameters:
<State>
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
Window
source marker, see
destination marker, see
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
CALC:DELT2:LINK:TO:DELT3 ON
Links D2 and D3.
CALCulate<n>:DELTamarker<ms>:LINK:TO:DELTa<md>
Window
source marker, see
destination marker, see
ON | OFF | 0 | 1
OFF | 0
Switches the function off
Marker
Marker
CALCulate<n>:DELTamarker<m>:X
Marker
Marker
Remote commands
845 845