Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
If a measurement is configured to wait for an external trigger signal in a remote control
program, remote control is blocked until the trigger is received and the program can
continue. Make sure this situation is avoided in your remote control programs.
For troubleshooting tips see
channels"
Parameters:
<Source>
Example:
Manual operation:
TRIGger[:SEQuence]:TIME:RINTerval <Interval>
This command defines the repetition interval for the time trigger.
Parameters:
<Interval>
Example:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
"Incompleted sequential commands - blocked remote
on page 1032.
IMMediate
Free Run
EXTernal
Trigger signal from the "Trigger Input" connector.
Trigger signal from the "Trigger In" connector.
IFPower
Second intermediate frequency
TIME
Time interval
VIDeo
Video mode is available in the time domain and only in the
Spectrum application.
*RST:
TRIG:SOUR EXT
Selects the external trigger input as source of the trigger signal
See
"Trigger Source"
See
"Free Run"
See
"External Trigger 1"
See
"Video"
See
"IF Power"
See
"I/Q Power"
See
"Time"
numeric value
Range:
*RST:
Default unit: S
TRIG:SOUR TIME
Selects the time trigger input for triggering.
TRIG:TIME:RINT 5
The sweep starts every 5 s.
See
"Repetition Interval"
IMMediate
on page 344
on page 344
on page 345
on page 345
on page 345
on page 345
on page 346
2 ms to 5000 s
1.0 s
on page 346
Remote commands
787
787
Publicité
