Rohde & Schwarz FPL1000 Manuel D'utilisation page 681

®
R&S FPL1000
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:MAXimum <Level>
This command defines the upper limit of a particular power class.
Note:
●
The last power class always has an upper limit of 200 dBm.
●
The upper limit of a power class must always be the same as the lower limit of the
subsequent power class.
●
The power class must already exist (see
ESPectrum<sb>:PCLass<pc>:COUNt
Suffix:
<n>
<li>
<sb>
<pc>
Parameters:
<Level>
Example:
Manual operation:
CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>:MINimum <Level>
This command defines the lower limit of a particular power class.
Note:
●
The first power class always has a lower limit of -200 dBm.
●
The lower limit of a power class must always be the same as the upper limit of the
previous power class.
●
The power class must already exist (see
ESPectrum<sb>:PCLass<pc>:COUNt
Suffix:
<n>
<li>
<sb>
<pc>
Parameters:
<Level>
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
CALCulate<n>:LIMit<li>:
irrelevant
irrelevant
1 to 3
1..n
power class
Range: -199.9 dBm to 200 dBm
Default unit: dBm
CALC:LIM:ESP:PCL1:MAX -40 dBm
Sets the maximum power value of the first power class to -40
dBm.
See "PMin/ PMax" on page 189
CALCulate<n>:LIMit<li>:
irrelevant
irrelevant
1 to 3
1..n
power class
Range: -200 dBm to 199.9 dBm
Default unit: dBm
Remote commands
on page 673).
on page 673).
681 681