Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
10.11.2.3
Special behavior of commands
Command
ABORT
ANNOT
AT
CAL
CF
CR
CT
CV
DET
ERR?
FA
FB
ID
M2
M3
MKACT
MKBW
MKPT
MKPX
OL?
OL
RB
RL
Manuel d'utilisation 1179.5860.09 - 12
Known Differences
Does not automatically set the command complete bit (bit 4) in the status byte. An addi-
tional DONE is required for that purpose.
Only frequency axis annotation is affected.
AT DN/UP: Step size
The CAL commands do not automatically set the command complete bit (bit 4) in the sta-
tus byte. An additional DONE command is required for that purpose.
Default value, range, step size
Default ratio Span/RBW
Formula for coupled sweep time
Default ratio RBW/VBW
DET? returns SAMP instead of SMP on the R&S FPL1000.
DET not automatically set the command complete bit (bit 4) in the status byte. An addi-
tional DONE is required for that purpose.
Deletes the error bit in the status register but always returns a '0' in response.
Default value, range, step size
Default value, range, step size
Default value, range, step size
Default value, range, step size
Only marker 1 is supported as the active marker.
Default value
Step size
Step size
Storage of instrument settings:
80 characters are returned as information on the instrument settings.
The contents of the 80 characters returned does not correspond to the original data con-
tents of the 8566A/8568A family.
Readout of instrument settings:
The 80 characters read by means of OL? are accepted as information on the correspond-
ing instrument settings.
The contents of the 80 characters read does not correspond to the original data contents
of the 8566A/8568A family.
Default value, range, step size
Default value, step size
Remote commands
Emulating other instruments' commands
1016
1016
Publicité
