Rohde & Schwarz FPL1000 Manuel D'utilisation page 715

®
R&S FPL1000
Manual operation:
Measuring the peak power
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PPEak:AVERage:RESult?
This command queries the average positive peak time domain power. The query is
only possible if averaging has been activated previously using
MARKer<m>:FUNCtion:SUMMary:AVERage
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<PeakPower>
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PPEak:PHOLd:RESult?
This command queries the maximum positive peak time domain power. The query is
only possible if the peak hold function has been activated previously using
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PHOLd.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
Suffix:
<n>
<m>
Return values:
<PeakPower>
Usage:
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PPEak:RESult?
This command queries the positive peak time domain power.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
Manuel d'utilisation 1179.5860.09 - 12
See "Results"
INITiate<n>:CONTinuous
Window
Marker
Peak power of the signal during the measurement time.
Query only
INITiate<n>:CONTinuous
Window
Marker
Peak power of the signal during the measurement time.
Query only
Configuring and performing measurements
on page 234
on page 705.
on page 620.
on page 620.
Remote commands
CALCulate<n>:
715 715