Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Manual operation:
Using delta markers
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer:MODE
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer:RESult?
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer:SPAN
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer[:STATe]
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer:MODE <Mode>
This command selects the way the results for a band power delta marker are dis-
played.
Suffix:
<n>
<m>
Parameters:
<Mode>
Manual operation:
CALCulate<n>:DELTamarker<m>:FUNCtion:BPOWer:RESult?
This command queries the results of the band power measurement.
Suffix:
<n>
<m>
Return values:
<Power>
Usage:
Manuel d'utilisation 1179.5860.09 - 12
Setting basic spectrum RF measurement parameters
See
"Band Power Measurement State"
See
"Switching All Band Power Measurements Off"
Window
Marker
POWer
Result is displayed as an absolute power. The power unit
CALCulate<n>:UNIT:POWer
depends on the
DENSity
Result is displayed as a density in dBm/Hz.
RPOWer
This setting is only available for a delta band power marker.
The result is the difference between the absolute power in the
band around the delta marker and the absolute power for the
reference marker. The powers are subtracted logarithmically, so
the result is a dB value.
[Relative band power (Delta2) in dB] = [absolute band power
(Delta2) in dBm] - [absolute (band) power of reference marker in
dBm]
For details see
"Relative band power markers"
*RST:
POWer
See
"Power Mode"
on page 385
Window
Marker
Signal power over the delta marker bandwidth.
Query only
Remote commands
on page 384
on page 385
................................................ 880
............................................. 880
................................................. 881
............................................. 881
setting.
on page 383.
886
886
Publicité
