Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
10.13 Deprecated commands
The following commands are provided for compatibility to other signal analyzers only.
For new remote control programs use the specified alternative commands.
CALCulate<n>:LIMit<li>:TRACe<t>
DISPlay[:WINDow<n>]:STATe
DISPlay[:WINDow<n>]:TYPE
HCOPy:ITEM:ALL
CALCulate<n>:LIMit<li>:TRACe<t> <TraceNumber>
This command links a limit line to one or more traces.
Note that this command is maintained for compatibility reasons only. Limit lines no lon-
ger need to be assigned to a trace explicitly. The trace to be checked can be defined
directly (as a suffix) in the new command to activate the limit check (see
CALCulate<n>:LIMit<li>:TRACe<t>:CHECk
Suffix:
<n>
<li>
<t>
Parameters:
<TraceNumber>
Example:
DISPlay[:WINDow<n>]:STATe <State>
This command changes the display state of the selected measurement window.
Note that this command is maintained for compatibility reasons only. Use the LAYout
commands for new remote control programs
(See
Suffix:
<n>
Parameters:
<State>
Manuel d'utilisation 1179.5860.09 - 12
............................................................................................... 1028
................................................................................................. 1029
.................................................................................................................. 1029
Window
Limit line
irrelevant
1 to 6
*RST:
CALC:LIM2:TRAC 3
Assigns limit line 2 to trace 3.
Chapter 10.7.1, "Working with windows in the
Window
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
....................................................................................... 1028
on page 913).
1
display",
Remote commands
Deprecated commands
on page 743).
1034
1034
Publicité
