Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
Example:
Manual operation:
[SENSe:]SWEep:COUNt:CURRent?
This query returns the current number of started sweeps or measurements. This com-
mand is only available if a sweep count value is defined and the instrument is in single
sweep mode.
Return values:
<CurrentCount>
Example:
Usage:
10.6.2
Configuring power measurements
The following commands work for several power measurements.
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult?
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:SELect
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>[:STATe]
[SENSe:]POWer:ACHannel:PRESet
[SENSe:]POWer:ACHannel:PRESet:RLEVel
[SENSe:]POWer:TRACe
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE <Mode>
This command selects the trace display mode for power measurements.
Suffix:
<n>
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
INIT:CONT OFF
Switches to single sweep mode.
DISP:WIND:TRAC:MODE AVER
Switches on trace averaging.
SWE:COUN 20
Sets the sweep counter to 20 sweeps.
INIT;*WAI
Starts the measurement and waits for the end of the 20 sweeps.
See
"Frequency Sweep"
See
"Zero Span"
on page 103
See
"Single Sweep / Run Single"
SWE:COUNt 64
Sets sweep count to 64
INIT:CONT OFF
Switches to single sweep mode
INIT
Starts a sweep (without waiting for the sweep end!)
SWE:COUN:CURR?
Queries the number of started sweeps
Query only
........................................................................................ 624
........................................................................... 625
.......................................................................................................... 625
Window
Remote commands
on page 103
on page 336
................................................... 621
................................................. 622
.................................................. 623
................................................. 624
627
627
Publicité
