Rohde & Schwarz FPL1000 Manuel D'utilisation page 616

®
R&S FPL1000
10.5 Selecting the operating mode and application
The following commands are required to select the operating mode or the application
and to configure a Sequencer in a remote environment.
●
Selecting the mode and applications
●
Performing a sequence of
●
Programming example: performing a sequence of measurements
10.5.1 Selecting the mode and applications
DISPlay:ATAB
INSTrument:CREate:DUPLicate
INSTrument:CREate[:NEW]
INSTrument:CREate:REPLace
INSTrument:DELete
INSTrument:LIST?
INSTrument:REName
INSTrument[:SELect]
DISPlay:ATAB <State>
This command switches between the MultiView tab and the most recently displayed
channel setup. If only one channel setup is active, this command has no effect.
Parameters:
<State>
INSTrument:CREate:DUPLicate
This command duplicates the currently selected channel setup, i.e creates a new chan-
nel setup of the same type and with the identical measurement settings. The name of
the new channel setup is the same as the copied channel setup, extended by a con-
secutive number (e.g. "IQAnalyzer" -> "IQAnalyzer 2").
The channel setup to be duplicated must be selected first using the INST:SEL com-
mand.
Example:
Usage:
Manual operation:
Manuel d'utilisation 1179.5860.09 - 12
measurements.................................................................. 614
................................................................................................................................. 610
.............................................................................................. 610
...................................................................................................... 611
................................................................................................. 611
................................................................................................................. 612
................................................................................................................... 612
.............................................................................................................. 613
............................................................................................................... 613
ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
INST:SEL 'IQAnalyzer'
INST:CRE:DUPL
Duplicates the channel setup named 'IQAnalyzer' and creates a
new channel setup named 'IQAnalyzer2'.
Event
See "Duplicate Current Channel"
Selecting the operating mode and application
........................................................................... 610
on page 89
Remote commands
........................ 616
616 616