Publicité
Les langues disponibles
Les langues disponibles
®
R&S
FPL1000
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:MANual
[SENSe:]POWer:ACHannel:REFerence:AUTO ONCE
This command sets the channel power as the reference for relative ACLR measure-
ments.
Example:
Usage:
Manual operation:
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO <RefChannel>
This command selects the reference channel for relative measurements.
You need at least one channel for the command to work.
Parameters:
<RefChannel>
Example:
Manual operation:
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:MANual <ChannelNumber>
This command defines a reference channel for relative ACLR measurements.
You need at least one channel for the command to work.
Parameters:
<ChannelNumber>
Manual operation:
10.6.4.5
Checking limits
The following commands configure and query limit checks for channel power and
ACLR measurements.
Manuel d'utilisation 1179.5860.09 - 12
Configuring and performing measurements
POW:ACH:REF:AUTO ONCE
Event
See
"Setting a fixed reference for Channel Power measure-
ments (Set CP Reference)"
MINimum | MAXimum | LHIGhest
MINimum
Transmission channel with the lowest power
MAXimum
Transmission channel with the highest power
LHIGhest
Lowest transmission channel for lower adjacent channels and
highest transmission channel for upper adjacent channels
POW:ACH:REF:TXCH:AUTO MAX
Selects the channel with the peak power as reference channel.
See
"Reference Channel"
Range:
1 to 18
*RST:
1
See
"Reference Channel"
Remote commands
............................................................ 638
.................................................... 638
................................................. 638
on page 143
on page 142
on page 142
644
644
Publicité
